[C320-list] Converting Dining Table to Full Bed

[Jerry's Iphone]

Ours is even and with blocks on our 890. Still a little uncomfortable where the cushions meet. We bought a roll up egg crate cushion to smooth out the bumps. Makes a big difference. 

Jerry Sheets

> On Jul 21, 2018, at 5:50 PM, Chris Burti <clburti at gmail.com> wrote:
> 
> Definitely factory installed. 1x2 batten softened corners and not noticeable. 
> 
> Best Regards,
> Chris Burti
> Statewide Title, Inc.  
> 
>> On Jul 21, 2018, at 3:32 PM, Troy Dunn <troutwarrior at gmail.com> wrote:
>> 
>> Chris-
>> 
>> Those blocks are not present on Hull #514.   I suspect they were added by a
>> previous owner?  Do you bang your legs on them?
>> 
>> T
>> 
>>> On Sat, Jul 21, 2018 at 3:24 PM, Chris Burti <clburti at gmail.com> wrote:
>>> 
>>> Dave,
>>> On #867 they are all level and all the same thickness. There are teak
>>> blocks attached to the locker sides that support the table when lowered and
>>> which maintain the correct height. If your filler cushion is somehow
>>> thinner than your settee cushions, add blocks under the table to raise the
>>> height to level.
>>> 
>>> Thanks,
>>> Chris Burti
>>> Farmville, NC
>>> 
>>> From: Dave Hupe
>>> Sent: Saturday, July 21, 2018 2:17 PM
>>> To: c320-list at lists.catalina320.com
>>> Subject: [C320-list] Converting Dining Table to Full Bed
>>> 
>>> Am I missing something?  When I want to convert our main cabin dining
>>> table to a full bed, I lift up/move the main cushion aside temporarily,
>>> loosen the table support pole knob, push the table all the way down, relock
>>> the table knob, put the main cushion back in place, then install the small
>>> filler cushion.   My problem...….the filler cushion is not nearly as thick
>>> as the main seat cushion.  So, the cushions are not even (there is a drop
>>> down onto the filler cushion.....not a comfortable "bigger" bed).
>>> Any suggestions??
>>> Dave Hupe1994 Cat 320 (#32)Holland, MI
>>> 
>>>