[C320-list] Converting Dining Table to Full Bed

[Darren Hulbert]

Ditto.. #816

> On Jul 27, 2018, at 6:23 PM, Joe Luciano <jnluciano at comcast.net> wrote:
> 
> My boat, hull number 1044, has a flat table (top and bottom) with a rounded edge.  It has the wooden blocks for support when the table is pushed down and locked in place.  The cushion fits nicely and everything is level…
> .
>> On Jul 27, 2018, at 1:21 PM, Troy Dunn <troutwarrior at gmail.com> wrote:
>> 
>> While getting ideas for a start battery install, I noticed that Emily Ann
>> (Hull #1107) has the factory installed salon table support blocks.   It
>> also appears that the salon table in those photos does not have a
>> surrounding fiddle.   I wonder if all the hulls with the blocks have a
>> table without fiddles?
>> 
>> Troy
>> S/V Wonky Dog
>> Hull #514
>> 
>>> On Mon, Jul 23, 2018 at 1:29 PM, Chris Burti <clburti at gmail.com> wrote:
>>> 
>>> The cleats that were factory installed on Commitment do a good job of
>>> supporting the table inner edge and tightening the post has sufficed. I
>>> haven’t slept on it enough to comment on the effect on sleeping comfort
>>> caused by the rolled bolster on the cushion edge other than to observe that
>>> I have not noticed it.
>>> 
>>> Best Regards,
>>> Chris Burti
>>> Commitment #867
>>> 
>>>> On Jul 21, 2018, at 3:36 PM, Dave Hupe <hoopdtwo at yahoo.com> wrote:
>>>> 
>>>> Chris-
>>>> I have no teak blocks on the edge of the lockers/seats to support the
>>> table (this would definitely be better for support than just the center
>>> post).  Also, there is no "stop" on the support rod rather than down all
>>> the way. Plus, I wouldn't feel safe trying to tighten down the knob at a
>>> slightly higher level and expect it to hold.
>>>> Teak blocks on the seats, or adding blocks under the table would help to
>>> keep the table slightly higher and adjust for the difference in cushion
>>> thicknesses.  I'll look at that and see if anyone else has this issue and
>>> another solution.
>>>> Thanks, Dave Hupe1994 Cat 320 (#32)Holland, MI
>>>> 
>>>> 
>>> 
>