[C320-list] Prop puller

[Jeff Smith]

If you do not want to have the prop puller shipped, you can use a traditional three-jaw puller from an auto parts store (should be loanable). Just don’t forget to put the cap on it so you do not leave an indention in your bronze shaft (guilty). However, if you get the strut bearing tool (it works great, by the way), consider changing the bellows on your dripless shaft if you have one installed. Once you pull your prop and change your strut bearing, might as well do that too.

Jeff
Sailmates
’94, #121

> On Oct 28, 2019, at 9:29 AM, Ted Harrison <tharrison at innovations-plus.com> wrote:
> 
> Jeff, look on the web site and fill in the form. You are in the US so there is a USA tool rep that can send you the tool. 
> 
> Check your strut bearing.  They have the tool to replace this  bearing as well. After all you are pulling the prop. 
> 
> For those in Canada that have pulled your boat out of the water, it is a good time to check the strut bearing and determine if it should be replaced!! Spring launch is only about 200 days away! 
> 
> Ted Harrison
> Catalina 320 association,  Canada tool rep
> Whitby Ontario
> 
>> On Oct 28, 2019, at 9:09 AM, danb70341 at gmail.com wrote:
>> 
>> What is address to send dues and what is the amount?
>> 
>> Sent from my iPad
>> 
>>> On Oct 28, 2019, at 8:55 AM, Ted Harrison <tharrison at innovations-plus.com> wrote:
>>> 
>>> Yes 
>>> 
>>> Ted Harrison
>>> 
>>>> On Oct 28, 2019, at 12:13 AM, Jeffrey Brown <oceanblues at mac.com> wrote:
>>>> 
>>>> Do we have a prop puller in our association tool kit?
>>>> 
>>>> Jeff Brown
>>>> 949-350-5123