[C320-list] Injector torque specs

[Timothy Woods]

Thanks, I just Googled and download the pdf manual.

Tim

On Sun, Jun 14, 2020, 10:46 AM Michael Leschisin <
mleschisin at imagestudios.com> wrote:

> Hey Tim,
>
> I cleaned and serviced my injectors this past winter.  I wasn’t having
> major issues, but I can tell the engine is running much smoother this
> spring.
>
> I assume you're asking about the two nuts that are on the back of the
> nozzle holder ring and hold the injector into the block?
> Those get tightened to 14.5 ft-lb.  That seemed like nothing to me, but
> the diesel shop I was working with said that the torque is that light so
> you don’t over tighten them and cause distortion to all of those small
> parts in the pre-combustion chamber (like those new cones).
>
> I have a PDF of the service manual that I could send you if you have an
> email address that can handle a 15.2mb document.
>
>
> Hope you’re back on the water soon,
>
>
> Michael Leschisin
> #995, Wild Blue Yonder
> Menominee, MI
>
>
>
>
>
> > On Jun 14, 2020, at 6:06 AM, Timothy Woods <woodstimothya at gmail.com>
> wrote:
> >
> > Good morning all,
> >
> > I was getting soot on the transom so I had my injectors rebuilt with new
> > cones. (3gm30f) Would anyone know what the toque specs are for the two
> hold
> > down nuts on the injector?
> >
> > Tim Woods
> > #375 Seven C's
>
>