[C320-list] Gemlux friction hinge(s) for port locker cover

[kskis at aol.com]

My notes aren't clear on the hinge model I used but I think I can figure it out by measuring once I'm back on the boat.  I know the hinges I used was a close enough match that allowed using the same holes as the hinge that it replaced.  I think 1209 TM but not positive.  Neil


-----Original Message-----
From: Ken McCrimmon <kenmccrimmon at hotmail.com>
To: C320-List at Catalina320.com <C320-List at Catalina320.com>
Sent: Tue, Feb 8, 2022 11:37 am
Subject: Re: [C320-list] Gemlux friction hinge(s) for port locker cover

Hi
I have been looking at the Gemlux hinges as well for my fridge top.  Which one did you end up using.

Ken
________________________________
From: C320-list <c320-list-bounces at lists.catalina320.com> on behalf of kskis at aol.com <kskis at aol.com>
Sent: February 8, 2022 11:25 AM
To: C320-List at Catalina320.com <C320-List at Catalina320.com>
Subject: Re: [C320-list] Gemlux friction hinge(s) for port locker cover

I love the gemlux hinges and use them for my stern lockers.  I also use them for my fridge.  However, for port locker I went with gas shocks because I didn't trust my skill set to end up with a nice clean look.  Neil Harmony #963.


-----Original Message-----
From: Frank Yaskin <frankya at comcast.net>
To: c320-list at lists.catalina320.com <c320-list at lists.catalina320.com>
Sent: Tue, Feb 8, 2022 11:20 am
Subject: [C320-list] Gemlux friction hinge(s) for port locker cover

I wonder if the continuous hinge on most 320's could have sections cut out, and replaced with 2 or 3  of the Gemlux friction hinges. The remaining sections of continuous hinge would provide support for lateral and shear loads, while the Gemlux hinges would provide the desired hold-open and slo-close function.

Frank
C-320 Blue Canute #380