[C320-list] Adler/Barbour refrigerator

[Ken McCrimmon]

Hi Bill
I replaced the Adler Barbour system, both the compressor and cold plate with a newer model last year.  If you just try to replace the compressor, you might end up with a problem if the fittings from the tubing don't match.  When i bought both parts, they did not fit together.  When I talked to the service department, they said I had a new cold plate and an older model compressor.  I had to send the compressor back and get a newer model.  I was pretty POed at the reseller for selling me something that would not go together.

Not to difficult a job if you have the right components.

Ken
________________________________
From: C320-list <c320-list-bounces at lists.catalina320.com> on behalf of --Bill via C320-list <c320-list at lists.catalina320.com>
Sent: April 22, 2024 2:52 PM
To: C320 List <C320-list at catalina320.com>
Cc: --Bill <ackermwi at yahoo.com>
Subject: [C320-list] Adler/Barbour refrigerator

When I purchased #240 it only had the evaporator section of the Adler Barbour system, no compressor section.  So currently I have 12V wires and plugged male and female tubing connections in the port locker. The tubing is still connected to the evaporator in the refrigerator/ice box.
To restore the system do I just need to connect a new compressor or do I need to start with a new evaporator/tubing in addition to a new compressor?  Is this a DIY job?

—Bill Ackerman
1995 #240
Gulfport FL