[C320-list] 'Sticky' Through-Hull Valves

Dave Hupe hoopdtwo at yahoo.com
Tue Apr 30 10:17:42 PDT 2024


The handle o-rings are tiny and would not be the reason for difficult operation. Their purpose is only to prevent water seepage around the handle shaft. I know this from rebuildng several valves.
Dave Hupe
1994 C320 #32

Yahoo Mail: Search, Organize, Conquer 
 
  On Tue, Apr 30, 2024 at 11:18 AM, Tony Kalish via C320-list<c320-list at lists.catalina320.com> wrote:   Hi Troy, thanks for your information.  I'm on the hard right now (Oak
Harbor Marina, Pasadena) and I totally understand the Chesapeake water (?)
issues...I'm heading to the boat today and will check out my thru-hull
valves.  Actually have the same 'sticky/binding issue with all of the
valves.  One thought is that the o-rings in the handle part might be
getting old (25 yrs) and may need to be replaced.  Apparently there is an
o-ring repair kit from Forespar--looking to see if available in Annapolis
somewhere--

thanks, Tony

On Mon, Apr 29, 2024 at 8:13 PM Troy Dunn via C320-list <
c320-list at lists.catalina320.com> wrote:

> Tony
>
> We keep our boat in Rock Hall.  Only slightly salty there compared to the
> ocean, but still a barnacle fiesta at times.  If you are having trouble
> with a particular thru hull it could be that you have marine growth inside
> the ball, as someone else noted this can be difficult to remove when the
> boat is in the water, but it is doable if it's actually barnacles or other
> hard/calciferous  marine growth.  You can test this theorey by pushing a
> small rod or wire up into the open valve from the outside…if it doesnt
> slide smoothly you may have growth.    The little white cap on the side of
> your handle is a plug, you can tie a string to it so you don’t lose it and
> insert it into the thru hull from the bottom of the boat.  Now you can
> safely remove hoses and prod around from the top side with the valve closed
> and/or open.  If you think you have hard growth, put a small section of
> hose back on then slowly pour some barnacle buster into the valve.
>
> Good luck.
>
>
> Troy
>
  


More information about the C320-list mailing list