[C320-list] Interior Table

[john at frostnet.net]

Good catch. Those, or the table where they touch, might need modification also


John
2007 C320MKII
Hull  #1118
Lake Guntersville, AL



-----Original Message-----
From: C320-list <c320-list-bounces at lists.catalina320.com> On Behalf Of surprise thompson87.com via C320-list
Sent: Monday, May 27, 2024 2:32 PM
To: C320-List at catalina320.com
Cc: surprise thompson87.com <surprise at thompson87.com>
Subject: Re: [C320-list] Interior Table

Don’t do that!  The table is supposed to be supported at three points when fully down. The other two are the wooden blocks attached to the fiberglass part of the seats. If you don’t lower the table all the way then the post will take all the weight and any significant off- center loading risks damage to the table top where it attaches to the post. 


> On May 26, 2024, at 11:50 AM, Dave Hupe via C320-list <c320-list at lists.catalina320.com> wrote:
> 
>  So, while we are on this topic ..... my table lowers/raises fine, but when down my filler cushion area (definitely thinner than the other cushions) on top of the table winds up being low.  So, it does not form a nice flat expanded bed.  We wind up putting items (blanket, etc.) beneath the filler cushion to try to even it out. I suppose i could push the table down just enough to make it level and turn the knob/lock, but I was concerned the table would slip down when weight is placed on it (the knob doesn't seem to lock into a hole in the post to keep it at the desired level. 
> Does anyone else experience this issue ...... any "fixes" to suggest??
> Dave Hupe
> 1994 C320 #32
> 
>