[C320-list] Autohelm Rudder Reference Transducer

[Jeff Church]

Thanks Tim.

Can the job be done without removing the guard? I was hoping that I might be 
able to leave the guard in place and fish the wires up from below.

JeffC

----- Original Message ----- 
From: "Timothy Grennan" <timgrennan at yahoo.com>
To: "C320-List" <C320-List at catalina320.com>
Sent: Thursday, January 12, 2006 7:42 PM
Subject: Re: [C320-list] Autohelm Rudder Reference Transducer


>I drilled through the deck and ran the wires through the other post. The 
>wire in the port side filled the pipe so running added wire was not 
>possible.Drilling throught the deck w/the guard off was a piece of cake.The 
>only hard part was to drill the tubing for the additional wire on the 
>starboard side. Make sure to fill the deck hole up w/silicone after the 
>wires are run.
>
> Jeff Church <jjemail at comcast.net> wrote:  I was just down at the yard (50 
> degrees in Chicago!) trying to figure out
> how to run the new wire for the rudder reference transducer up thru the
> binnacle post. If anyone has run additional wire up to the instrument pod,
> I'd appreciate some advice. Will another wire fit in the port-side post? 
> Am
> I better off drilling thru the liner and deck into the starboard post? I
> think there were previous comments that either option could be 
> problematic.
>
> Thanks
>
> JeffC