[C320-list] PYI PSS help

[Ralph Winkler]

I did this exchange two years ago.  You can easily run the tube up the 
inside of the engine compartment to a level well above the waterline.
Ralph Winkler
#394
----- Original Message ----- 
From: "Dave Anderer" <danderer at udel.edu>
To: <C320-List at Catalina320.com>
Sent: Monday, April 28, 2008 4:56 PM
Subject: Re: [C320-list] PYI PSS help


>I ran a hose aft and then up to the top of the port locker.  (That is, 
>open the port aft locker, and the vent terminates just inside the  hatch 
>there, towards the centerline.)
>
>
> On Apr 28, 2008, at 4:42 PM, Joseph A Tamucci wrote:
>
>> I recently installed the replacement to the PYI PSS shaft seal that is
>> vented. It requires that the vent hose be installed 2 ft above the
>> watereline. It is not obvious to me where I can run the vent hose to 
>> achieve
>> the necessary height. Any suggestions would be welcomed.
>>
>> Thanks,
>>
>> Joe Tamucci #619
>>
>
>
> -- 
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
>
> 


-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.