[C320-list] Entry Stantion Replacement

[pat reynolds]

You need to remove the section of trim and then use a hole saw to cut an opening into the liner behind to get easier access to the large and two small nuts on the stantion.  Have someone with you to remove and replace the smaller screws and nuts.  thin fingers or larger access holes help.  Eventually you will need to do this with all the stantions.  

--- On Thu, 9/10/09, Max Ruddy <maxruddy at gmail.com> wrote:

> From: Max Ruddy <maxruddy at gmail.com>
> Subject: [C320-list] Entry Stantion Replacement
> To: C320-list at catalina320.com
> Date: Thursday, September 10, 2009, 10:07 PM
> I just purchased a 1995 320 Hull #270
> and need to replace the starboard entry stantion.  I am
> ordering a new one from
> Catalina.  As all of you probably already know this is
> a unique double base stantion.  Does anyone any
> installation recommendations
> as I am new to this type of repair.  Also, this has
> two screws in the base and I can't tell if their is a pin
> that goes into the deck or if that was the part
> that was broken off.
> 
> Thanks in advance,
> 
> Max
> 
>