[C320-list] Entry Stantion Replacement

[Max Ruddy]

Ok, they sure thought through the stanchion replacement design didn't  
they.  I may have more questions once I get back on the boat.  Thanks  
for your help Pat.

Max
On Sep 12, 2009, at 8:47 AM, pat reynolds <lorasalum at yahoo.com> wrote:

> You need to remove the section of trim and then use a hole saw to  
> cut an opening into the liner behind to get easier access to the  
> large and two small nuts on the stantion.  Have someone with you to  
> remove and replace the smaller screws and nuts.  thin fingers or  
> larger access holes help.  Eventually you will need to do this with  
> all the stantions.
>
> --- On Thu, 9/10/09, Max Ruddy <maxruddy at gmail.com> wrote:
>
>> From: Max Ruddy <maxruddy at gmail.com>
>> Subject: [C320-list] Entry Stantion Replacement
>> To: C320-list at catalina320.com
>> Date: Thursday, September 10, 2009, 10:07 PM
>> I just purchased a 1995 320 Hull #270
>> and need to replace the starboard entry stantion.  I am
>> ordering a new one from
>> Catalina.  As all of you probably already know this is
>> a unique double base stantion.  Does anyone any
>> installation recommendations
>> as I am new to this type of repair.  Also, this has
>> two screws in the base and I can't tell if their is a pin
>> that goes into the deck or if that was the part
>> that was broken off.
>>
>> Thanks in advance,
>>
>> Max
>>
>>
>
>
>