[C320-list] Need help please.....Portlight Gasket

[sail320 at hotmail.com]

Jon,
I measured the portlight - it is 12.2 x 5.25. I measured the plexiglass portion. Hope this helps.
Becky

Jon Vez <jonvez at comcast.net> wrote:

>Thanks Becky. My concern is that these are exactly the size I ordered as well. But when I measured my ports, the lens is 5.5x12.25! I can't believe that for all the boats out there I have a unique size. I just ordered the Size 2, but I don't think that will fit either. I will call Catalina on Monday.
>How did you address the horizontal gaps? Did you recaulk them? I can't figure out how to make them uniform so I'm afraid to make a bigger mess of it by sraping them out and redoing. Any advice would be appreciated! This has turned into a classic boat project--what should have been straightforward, not so much....
>
>Thanks again...
>
>Regards,
>
>Jon Vez
>Solstice #582
>
>-----Original Message-----
>From: c320-list-bounces at lists.catalina320.com [mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of sail320 at hotmail.com
>Sent: Friday, April 30, 2010 11:56 PM
>To: C320-List at Catalina320.com
>Subject: Re: [C320-list] Need help please.....Portlight Gasket
>
>Jon,
>I just install gaskets from Catalina Direct - Lewmar 5 x 12.
>They fit perfectly. My boat is 1995 #201.
>Becky
>
>Jon Vez <jonvez at comcast.net> wrote:
>
>>Thanks Chris. They are referred to as size 1, which is what I ordered, so
>>I'm hoping I can determine what I need...
>>
>>
>>
>>-----Original Message-----
>>From: c320-list-bounces at lists.catalina320.com
>>[mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of Chris Descher
>>Sent: Friday, April 30, 2010 4:46 PM
>>To: C320-List at Catalina320.com
>>Subject: Re: [C320-list] Need help please.....Portlight Gasket
>>
>>I ordered mine from these guys:
>>
>>DOWNWIND MARINE
>>2804 Canon St.,San Diego. Ca. 92106
>>
>>www.downwindmarine.com
>>
>>Phone: 619-224-2733
>>Fax:    619=224-7683
>>
>>I have 1998 hull #500, and I think that they just referred to them as Lewmar
>>size 1 gaskets.
>>
>>Chris
>>
>>-----Original Message-----
>>From: c320-list-bounces at lists.catalina320.com
>>[mailto:c320-list-bounces at lists.catalina320.com]On Behalf Of Jon Vez
>>Sent: Friday, April 30, 2010 3:39 PM
>>To: C320-List at Catalina320.com
>>Subject: [C320-list] Need help please.....Portight Gasket
>>
>>
>>Long story short, I started my rebedding project today and once everything
>>was out and cleaned I found the gaskets are the wrong size! I ordered per
>>the part number referenced here (1989600) for the "Old Style" ports and they
>>are simply too small. Anyone have any idea what the right part number for
>>these are?
>>
>>These are the ports with the horizontal caulking installed on a '99 boat.
>>Any assistance would be greatly appreciated!
>>
>>
>>
>>Regards,
>>
>>
>>
>>Jon Vez
>>
>>Solstice #582
>>
>>
>
>