[C320-list] C320-list Digest, Vol 1200, Issue 1

[H. M.]

I'm also interested in other users solutions...

On 8/18/11, c320-list-request at lists.catalina320.com
<c320-list-request at lists.catalina320.com> wrote:
> Send C320-list mailing list submissions to
> 	c320-list at lists.catalina320.com
>
> To subscribe or unsubscribe via the World Wide Web, visit
> 	http://lists.catalina320.com/listinfo.cgi/c320-list-catalina320.com
> or, via email, send a message with subject or body 'help' to
> 	c320-list-request at lists.catalina320.com
>
> You can reach the person managing the list at
> 	c320-list-owner at lists.catalina320.com
>
> When replying, please edit your Subject line so it is more specific
> than "Re: Contents of C320-list digest..."
>
>
> Today's Topics:
>
>    1. Asym halyard block or second jib halyard? (Pat Ireland)
>    2. Perkins Raw Water Pump Follow Up (Welch, Myron D)
>    3. Re: Asym halyard block or second jib halyard? (Chris Burti)
>    4. Re: Asym halyard block or second jib halyard? (Pat Ireland)
>
>
> ----------------------------------------------------------------------
>
> Message: 1
> Date: Wed, 17 Aug 2011 17:43:47 -0700
> From: Pat Ireland <cherie320 at gmail.com>
> To: C320-List at catalina320.com
> Subject: [C320-list] Asym halyard block or second jib halyard?
> Message-ID:
> 	<CAB3EGmuCnOmZG671JgkFaQYEzDxy_Ln64yyw_N5seCh3+jnyPg at mail.gmail.com>
> Content-Type: text/plain; charset=ISO-8859-1
>
> All
>
> Your help is appreciated.  I have two questions.  If you only have one light
> air sail, should it be a jib or an asymmetrical spinnaker?  And is it best
> to fly It from a block on a spinnaker crane or is there a second jib halyard
> block available.  My pictures of the 320 mast head look like there is only
> one shieve, but the mast drawings show two.  The pictures show a strap that
> centers the furler halyard and it looks like it would block the use of a
> second halyard.  Going to start cruising the 320 site for mast head pictures
> next.
>
> When we purchased Cherie, I believed we need better heavy and light air
> sails.  We have the heavy air condition reasonably covered and I'm looking
> to address the light air conditions.  Since the intention is to keep a heavy
> air Dacron jib on the head sail furler, the two approaches under
> consideration are 1) use a light weight 150 jib and free fly it on a luff
> wire or rope and 2) use an asymmetrical spinnaker.  The jib would allow us
> to point higher and perform through all points of sail.  Therfore it was my
> original preference.  However, I am concerned that the motion of the boat
> will shake the air out of a jib when we run down wind.  Since reaching and
> running will likely makeup most of of our light air sailing, I am
> reluctant to optimize for windward work at the expense of off the wind
> performance.
>
> And yes, the iron jib works quite well in all of these conditions and may
> well be a better solution, but I would really like to expand our ability to
> sail as the wind drops off.
>
> Any thoughts would be appreciated.  Your input would be helpful.
>
> Pat, 801
>
>
> ------------------------------
>
> Message: 2
> Date: Thu, 18 Aug 2011 01:57:42 +0000
> From: "Welch, Myron D" <myron-welch at uiowa.edu>
> To: "C320-List at Catalina320.com" <C320-List at Catalina320.com>
> Subject: [C320-list] Perkins Raw Water Pump Follow Up
> Message-ID: <71842F20-26FE-4DDD-AE27-C669B8BFE3A4 at uiowa.edu>
> Content-Type: text/plain; charset="us-ascii"
>
> After much work finding a replacement pump, the job is finally done. Some of
> you have asked for a follow up.
>
> I found a pump at Diesel Parts Direct for $598 and then Trans Atlantic
> Diesel for $404.  Torresen found it for $237 or $119 for the rebuild kit, so
> I had them ship me the new pump. Unfortunately, it was the fresh water pump,
> not the raw water. Their supplier would have to have one shipped from
> England at close to $600.
>
> I then purchased the pump from TAD. They shipped part #24950-1701 which
> looked quite different than our #24950-1101. Rather than a round impeller
> cover with 6 screws, it has a shield shape with 3 cap screws (which should
> be easier to change).  Also, unlike our exposed shaft, the shaft is
> completely covered and has 4 weep holes.
>
> After much discussion with the helpful people at TAD, they called England
> and were assured that this is the correct replacement.  I just had to remove
> and then install the drive gear on the new pump and it dropped in easily.
>
> I will now rebuild the old pump and keep it for a spare.
>
> I hope this information is helpful to fellow Perkins owners.
>
> Myron Welch
> Wind Instrument #238
> Iowa City, Iowa
>
> Sent from my iPod Touch
>
> ------------------------------
>
> Message: 3
> Date: Wed, 17 Aug 2011 22:44:25 -0400
> From: Chris Burti <clburti at gmail.com>
> To: C320-List at catalina320.com
> Subject: Re: [C320-list] Asym halyard block or second jib halyard?
> Message-ID:
> 	<CAAAgXkygw+1PfpWVOa+x096-VWjR1KwWK9xSy_-pfgrLLtf-iQ at mail.gmail.com>
> Content-Type: text/plain; charset=ISO-8859-1
>
> A meaningful depends on the strength of your prevailing winds and when
> you sail. We have to take the wind as we find it because our sailing
> opportunities are limited by our work schedules. In this area it is
> not uncommon to go from zip to 20 knots and back in the same day. Some
> our favorite sailing grounds will often see 30 knots. We have a stock
> 135 on the furler and we carry an asymmetrical spinnaker in the
> locker.
>
> There are two forward and two aft sheaves on the mast. We have a
> halyard on the second block and yes there is some contact...I haven't
> noticed much adverse wear, but if we flew it more I would consider a
> crane and a bowsprit.
>
> On Wed, Aug 17, 2011 at 8:43 PM, Pat Ireland <cherie320 at gmail.com> wrote:
>> All
>>
>> Your help is appreciated. ?I have two questions. ?If you only have one
>> light
>> air sail, should it be a jib or an asymmetrical spinnaker? ?And is it best
>> to fly It from a block on a spinnaker crane or is there a second jib
>> halyard
>> block available. ?My pictures of the 320 mast head look like there is only
>> one shieve, but the mast drawings show two. ?The pictures show a strap
>> that
>> centers the furler halyard and it looks like it would block the use of a
>> second halyard. ?Going to start cruising the 320 site for mast head
>> pictures
>> next.
>>
>> When we purchased Cherie, I believed we need better heavy and light air
>> sails. ?We have the heavy air condition reasonably covered and I'm looking
>> to address the light air conditions. ?Since the intention is to keep a
>> heavy
>> air Dacron jib on the head sail furler, the two approaches under
>> consideration are 1) use a light weight 150 jib and free fly it on a luff
>> wire or rope and 2) use an asymmetrical spinnaker. ?The jib would allow us
>> to point higher and perform through all points of sail. ?Therfore it was
>> my
>> original preference. ?However, I am concerned that the motion of the boat
>> will shake the air out of a jib when we run down wind. ?Since reaching and
>> running will likely makeup most of of our light air sailing, I am
>> reluctant to optimize for windward work at the expense of off the wind
>> performance.
>>
>> And yes, the iron jib works quite well in all of these conditions and may
>> well be a better solution, but I would really like to expand our ability
>> to
>> sail as the wind drops off.
>>
>> Any thoughts would be appreciated. ?Your input would be helpful.
>>
>> Pat, 801
>>
>
>
>
> --
> Chris Burti
> Farmville, NC
>
>
> ------------------------------
>
> Message: 4
> Date: Wed, 17 Aug 2011 21:17:29 -0700
> From: Pat Ireland <cherie320 at gmail.com>
> To: C320-List at catalina320.com
> Subject: Re: [C320-list] Asym halyard block or second jib halyard?
> Message-ID:
> 	<CAB3EGmsLNb3AzY7ogkSaY=vUVSUYb5Qm_1Zds7ScAc=YKQASMQ at mail.gmail.com>
> Content-Type: text/plain; charset=ISO-8859-1
>
> Bert
>
> Thanks - we have similar wind varability and therefore a requirement for a
> wider range of capability.  Found a set of pictures in the 320 gallery.
> Clarifies the configuration at the mast head.  And your experience helps.
> Appreciate the info.
>
> Pat, 801
>
>
> End of C320-list Digest, Vol 1200, Issue 1
> ******************************************
>