[C320-list] Tool program & Stanchion nuts

[argates2nd at comcast.net]

I was able to get at those nuts without cutting -- but I was sore for a few days from the contortion. 

Rollie  #182 


----- Original Message ----- 
From: "Allan S. Field" <allan.field at verizon.net> 
To: C320-List at Catalina320.com 
Sent: Saturday, May 14, 2011 10:33:06 AM 
Subject: Re: [C320-list] Tool program 

Herb - The hole saw I have cuts a 2.5-inch hole.  My memory however is that 
I thought about using a Dremel to cut away the fiberglass panel in order to 
get to the nuts behind.  Either that or an angled ratchet?  I have a Dremel, 
it is not part of the toolbox program, but would be glad to lend it to you 
if you think that would do the trick.  But first, I would suggest asking the 
list for ideas of how to access these nuts; I have never done so. - Allan 
FIELD 

-----Original Message----- 
From: c320-list-bounces at lists.catalina320.com 
[mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of 
hcreech at comcast.net 
Sent: Saturday, May 14, 2011 8:50 AM 
To: C320-List 
Subject: [C320-list] Tool program 

I need to obtain a hole saw from the tool program. I need the one that will 
allow me to address a stanchion leak above the aft stateroom. If Allan 
Fields could contact me directly at hcreech at comcast.net I would be 
appreciable. 

Thanks, 
Herb Creech 
Cloud Chaser 606