[C320-list] Mast gate

[hcreech at comcast.net]

Chris, 
I found a perfect match to the knurled head screws at Lowes. 

Herb Creech 
Cloud Chaser 606 




----- Original Message -----
From: "Chris Burti" <clburti at gmail.com> 
To: C320-List at catalina320.com 
Sent: Tuesday, June 12, 2012 12:09:35 PM 
Subject: Re: [C320-list] Mast gate 

I did Irv, but actually purchased it from Layline, their distributor. 

The fit was decent, but I had to bend it a bit and play around with 
the alignment in order to get the slugs to slide smoothly as advised 
by Layline and list conversation. It took less than ten minutes and 
the gate works very well. Once you have the alignment exactly the way 
you want it, scribe a line in the mast with a scratch awl and you can 
adjust it instantly whenever you bend the main back on after removing 
it. 

Once in a great while, a slug will hang on the gate, but I found that 
if I just ease the halyard enough to drop the slug a little bit, it 
will go on by on the next pull. 

I have OEM knurled headed screws, if your holes are stripped and you 
want use the same size, you can fill the hole with J-B Weld aluminum 
filled epoxy, redrill and fill. Youll have to look up atap chart for 
the drill size for yoyr screw. 

http://www.imperialsupplies.com/pdf/I_Tap&DieChart.pdf 

On Tue, Jun 12, 2012 at 8:33 AM, Irving Grunes <igrunes at gmail.com> wrote: 
> Saw discussing on archive 
> But has anyone recently bought a replacement gate from Charleston and did 
> it fit. 
> Also screw holes on mast stripped. What size drill and tap thread did you 
> use? 
> Irv GRune2002 #851 



-- 
Chris Burti 
Farmville, NC