[C320-list] Rudder Problem

[Millers]

Joe,  I am away until next week and can better answer your question then. When you lean through the aft cabin access door you are looking at the rudder post.   I do not remember if the post has a grease fitting, if not lift the SS cap and force some grease as best you can into the space between the post and support tube.  Rotate the rudder and pack more in. See if the problem goes away or diminishes. 
Grease I use is waterproof and same recommend for cpp. I can provide spec next week if needed.
Art

Sent from my iPhone

On May 8, 2013, at 7:09 PM, Joseph R Aberdale <summerwind3 at comcast.net> wrote:

> Where do you apply the grease? Any particular type of grease?
> 
> Thanks Art.
> 
> On May 8, 2013, at 6:50 PM, Millers <millers1 at aol.com> wrote:
> 
>> Joe,  with the guidance provided by mike crawl into aft steering and inspect while an other person turns the wheel. I suspect a dry rudder shaft.   May need to be greased.  Art
>> 
>> Sent from my iPhone
>> 
>> On May 8, 2013, at 6:42 PM, Joseph R Aberdale <summerwind3 at comcast.net> wrote:
>> 
>>> Mike,
>>> 
>>> The rudder still turns when turning the wheel. Would it be possible to still work if there is a slipped steering cable off one of the pulley's?
>>> 
>>> Thank you Mike.
>>> 
>>> On May 8, 2013, at 6:11 PM, William Ott <wmo48 at yahoo.com> wrote:
>>> 
>>>> Joe,
>>>> Have you inspected the rudder quadrant cabling and pulled the inspection cover from the overhead in the aft cabin?  You could have slipped a steering cable off one of the idler pulleys.
>>>> Mike Ott
>>>> 'Amanda Lu'
>>>> #508 
>>>> 
>>>> Sent from my iPad
>>>> 
>>>> On May 8, 2013, at 5:53 PM, Joseph R Aberdale <summerwind3 at comcast.net> wrote:
>>>> 
>>>>> My boat is on the hard ready to launch next week. When turning the wheeI I found that there is a rumbling noise with considerable vibration in the wheel and pedestal holding the electronics. This condition was not there at all when hauling the boat out last fall. I appreciate any thoughts you might have regarding the cause of this.  
>>>>> 
>>>>> Thank you.
>>>>> 
>>>>> Joe Aberdale
>>>>> #908
>