[C320-list] Prop

[resloat]

Some changes must have been made since 2000 to the exhaust hose routing as 
in my hull 894 (2002) the transmisson ratio stamped on the transmission is 
easy to read.  I did an Autoprop prop and for my engine 3GM30F European the 
transmisson ratio was 2.21.  The Yanmar owner's manual lists 2 transmissions 
for the 3 GM30F.  Both are Kanzakis.  KM2P transmission has either a 2.21 or 
a 2.62 ratio and the KM3P has a 3.2 forward gear ratio.


Bob Sloat
----- Original Message ----- 
From: "Martin Rosenberg" <martinlrosenberg at gmail.com>
To: <C320-List at catalina320.com>
Sent: Monday, November 25, 2013 5:48 PM
Subject: Re: [C320-list] Prop


> Good idea, I'll try that. My problem appears to be paint that is so thick
> that you can't differentiate the imprint but maybe the chalk will help.
> Martin Rosenberg
> "Avalon"   #823
>
>
> On Mon, Nov 25, 2013 at 3:40 PM, Colin Evans <twosailors at bigpond.com> 
> wrote:
>
>> I had the same problem with the hose in the way.   I rubbed ours with
>> chalk,
>> then took a picture of it with my phone.  It is 2.21 on ours
>> *************************
>> Regards
>> Colin Evans
>> Watermark
>> 2000 C320 # 774
>> Lake Macquarie, Australia
>>
>>
>>
>>
>>
>> -----Original Message-----
>> From: c320-list-bounces at lists.catalina320.com
>> [mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of Martin
>> Rosenberg
>> Sent: Tuesday, 26 November 2013 7:24 AM
>> To: C320-List at catalina320.com
>> Subject: Re: [C320-list] Prop
>>
>> Bruce,
>>   How did you do a pencil rubbing? The exhaust hose is only about an inch
>> from the transmission on my boat so I can barely get in there. I really
>> don't want to remove the hose just to read the plate.
>>   That would be worse than when I had to remove the vent hose and unscrew
>> the fitting on my waste tank so I could see how full it was. BTW, the
>> previous owner had stored the boat for the winter with a FULL tank.
>> Martin Rosenberg
>> "Avalon"  #823
>>
>>
>> On Mon, Nov 25, 2013 at 12:50 PM, Bruce Heyman <bruceheyman at cox.net>
>> wrote:
>>
>> > Diane,
>> > This summer I did some serious maintenance on my Yanmar, including
>> chasing
>> > all the rust and repainting  (I now insist that everyone that comes on
>> > board has to ogle the engine.  My wife would love it if I would put the
>> > engine covers back on).  The ratio is stamped on the back of the
>> > transmission.  I didn't realize that it was until I had stripped all 
>> > the
>> > paint off to clear up bad corrosion in that area.  Before you remove 
>> > the
>> > paint (unless you too have corrosion there) you might try doing a 
>> > pencil
>> > rubbing.  Mine was 2.21 (from memory) and we have a 2000.
>> > Good luck,
>> > Bruce
>> >
>> > Bruce Heyman
>> > bruceheyman at cox.net
>> > (949) 289-8400
>> > Somerset #671 Dana Point, CA
>> >
>> > -----Original Message-----
>> > From: c320-list-bounces at lists.catalina320.com [mailto:
>> > c320-list-bounces at lists.catalina320.com] On Behalf Of Diane Fowler
>> > Sent: Monday, November 25, 2013 6:29 AM
>> > To: C320-List at Catalina320.com
>> > Cc: C320-List at catalina320.com
>> > Subject: [C320-list] Prop
>> >
>> > We are trying to buy a flex oh fold Prop, and the manufacturer wants to
>> > know if our gear reduction is one 2.  21. or one  2.   62.   #948.
>> Yanmar.
>> > 3gm.   Anyone know ???  Thanks,  captain Diane
>> >
>> > Sent from my iPhone
>> >
>> > > On Nov 25, 2013, at 9:25 AM, "Brian/Carol McLamb" <
>> bjcnmclamb at gmail.com>
>> > wrote:
>> > >
>> > > Hello Graeme.  I have not physically measured it myself, but our 
>> > > marina
>> > and
>> > > those I travel to use 33 ft.  I believe it is closer to 32 ft 4" in
>> > > actuality.  Brian s/v Serenity # 1075 out of Oriental, NC.
>> > >
>> > >
>> > >> On Mon, Nov 25, 2013 at 9:16 AM, Graeme Clark <cg at skyflyer.co.uk>
>> > wrote:
>> > >>
>> > >> Has anyone actually measured their 320 end to end to get a true LOA
>> > >> including the pulpit and projection at the rear of the boarding
>> ladder.
>> > >>
>> > >> I just ask because my marina is trying to charge us based on 10.4
>> metres
>> > >> (34ft 1.5") which they claim they have measured which seems a bit on
>> the
>> > >> high side to me!
>> > >>
>> > >> I'm 250 miles away so can't just nip down to the yard and measure 
>> > >> it!
>> > >>
>> > >> Thanks
>> > >>
>> > >> Graeme
>> > >> #303, Simia, 1996
>> >
>> >
>>
>>
>