[C320-list] Holding Tank matters

[tharrison at innovations-plus.com]

And maybe replace the sensor! The new one can tape on the outside of thank. Important to install it before you put the new tank back in place. 

Ted 

Sent from my iPhone

> On Mar 21, 2014, at 4:37 PM, Warren Updike <wupdike at hotmail.com> wrote:
> 
> Joe, Elizabeth, whoever, on our #62 we replaced the original holding tank
> with a 22 gal. Ronco B348 tank. I have an article and a number of pictures.
> One shows the location of the thru-hull in relation to the tank. Removing
> the tank requires cutting the old hoses close to the fittings, plugging the
> open hoses, and rotating the tank from the outboard end up before you can
> lift the tank out. The new tank went in, in opposite fashion. This was not
> the most difficult project I’ve done; but, it is a lot of work. Time and
> patience are necessary.
> 
> E-mail me off-list and I’ll send the article and pictures.
> 
> 
> 
> Warren and Pattie Updike
> 
> 1994 C320 "Warr de Mar" #62
> 
> 
> 
> From: Elizabeth Schwartz
> 
> Sent: ‎Friday‎, ‎March‎ ‎21‎, ‎2014 ‎12‎:‎27‎ ‎PM
> 
> To: 320
> 
> Cc: 320
> 
> Thanks.....I'm aware of the general location. If the holding tank needs 
> 
> to be removed for any reason, the stem of the thru hull may impact that 
> 
> process, if put in the way. I'm trying to decide if it should 
> 
> go outboard of the holding tank, or forward of the right side close to 
> 
> battery location.......Thanks....Joe
> 
>>> On Mar 21, 2014, at 5:43, Elizabeth Schwartz  wrote:
> 
> 
>>> ahoy all.....I'm new to the C 320 group. Recently purchased 1995 hull
> 
>>> #245. Can someone send me a photo of the location of the holding tank
> 
>>> macerator discharge thru hull, that best allows for holding tank
> 
>>> removal if necessary?  Also, has anyone drilled out weep holes in the
> 
>>> "hollow" floor grid structure? Thanks.....Joe     
> 
> 
> 
> 
>