[C320-list] Throttle Creep

[Pat Ireland]

Used socket drive Phillips to get ours off.  Long extension lets you get above to keep force on the bit.  

Pat, 802

Sent from my iPhone

> On Sep 8, 2015, at 3:30 PM, Scott Thompson <surprise at thompson87.com> wrote:
> 
> I had a devil of a time removing the screws that hold the compass when I did this. I was afraid I would break them I had to apply so much torque. I strongly recommend replacing them with the ones that Edson recommends as replacements to avoid future seizing. Newer boats may have this already. Sorry but I don't think I kept the part number.
> 
> Scott Thompson
> Surprise, #653
> 
>> On 9/8/2015 10:51 AM, Dick Walker wrote:
>> There is screw where you can adjust your throttle friction, but you have to remove the compass
>> 
>> You might as well grease the gear if you do it
>> 
>> Also use an antiseizing lib on the 4 bolts you Ned to remove to get the compass off.
>> 
>> A hint mark the compass position with masking tape do it will be aligned exactly the same
>> 
>> 
>> 
>> Cheers
>> 
>> 
>> 
>> Dick Walker
>> 740 Olive Ave.
>> Coronado ,CA 92118
>> 619.435.8986
>> 
>> 
>> 
>>> On Sep 8, 2015, at 16:45, Kirk Mueller <kirkm753 at gmail.com> wrote:
>>> 
>>> This message has no content.
>