[C320-list] Port side gate stanchion replacement

[Warren Updike]

Working with the stanchions is one of the more frustrating jobs I've done. I've done most of it; but, used our yard staff for the port gate stanchion. They cut a slot out of the "molded in cover" to facilitate the re-installation of the stanchion. This is not a problem (for me.)
Here is a trick I've used on other hard to reach areas: use a small dots of butyl rubber to hold the nut and washer assemblies together. Then with the wrench put in place and secure. I'm using butyl rubber for most bedding jobs so had some hanging around. 
The bigger issue is that Catalina used light-weight fender washers with no backing place. In truth, some of the spaces would not allow for a backing plate. The underside of the deck in places, I found was too fragile for the original washers as they were pulled into the deck and were cup-shaped when I removed them. 
Hope this helps someone.

Warren and Pattie Updike
1994 C320 "Warr de Mar" #62
Middle River, Chesapeake Bay

-----Original Message-----
From: Ken Geiger [mailto:kendgb at aol.com] 
Sent: Wednesday, August 24, 2016 4:27 PM
To: C320-List at Catalina320.com
Subject: Re: [C320-list] Port side gate stanchion replacement

Hi Daryle,  I have not removed/replaced the port side gate stanchion but have done the starboard side.  It was fairly easy to remove but reinstallation was a 2 person job and required a lot of cursing and swearing, glue, tape and some special clothes hanger wire tools to hold the 1/4" washes and nuts to get them manoeuvred and the thread started. The larger 1/2" nut was by comparison easy but not that easy.  There was a fibre glass web on starboard side (maybe the same as what you are encountering that did make it much more difficult.  Cutting it out would have helped but I worried about doing that.  I also had some of the nuts and washers fall and disappear forever, so had to get spares.

Good luck

FWIW

Ken

 

 

 

---- Original Message ----
From: Daryl Hunt <drhunt at rochester.rr.com>
To: C320 List <c320-list at lists.catalina320.com>
Sent: Wed, Aug 24, 2016 3:47 pm
Subject: [C320-list] Port side gate stanchion replacement

    Just noticed cracks in the weld and bend in my port side gate stanchion, the one shaped like an "h".  Bought a new one from Cat Direct.  Removed the microwave to access the forward bolts (easy).  The aft bolts are in the cupboard aft of the microwave but there's a molded in cover for the wiring harness that makes it impossible to get to the bolts.  Has anyone run into this problem?  Thought I'd check before cutting a hole in the cover.thanks, DarylDaryl HuntC320 #660 BelieveRochester, NY / Lake Ontario