[C320-list] Converting Dining Table to Full Bed

[Chris Burti]

Definitely add the blocks. They must have been a later upgrade because ours are definitely factory installed. 

Best Regards,
Chris Burti
Statewide Title, Inc.  

> On Jul 21, 2018, at 3:52 PM, Scott Thompson <surprise at thompson87.com> wrote:
> 
> Blocks are present on hull 653 (1999), and the cushions are even when the table is on the blocks. I would not trust the post alone to provide adequate support without these. We are second owner, so possibly the first owner did this. But I doubt it since the boat was fairly new and seemed pretty much stock when we bought her. (No longer after 19 years!)
> 
> Scott Thompson
> 
> Surprise, #653 (1999)
> 
> 
>> On 7/21/2018 3:36 PM, Dave Hupe wrote:
>>  Chris-
>> I have no teak blocks on the edge of the lockers/seats to support the table (this would definitely be better for support than just the center post).  Also, there is no "stop" on the support rod rather than down all the way. Plus, I wouldn't feel safe trying to tighten down the knob at a slightly higher level and expect it to hold.
>> Teak blocks on the seats, or adding blocks under the table would help to keep the table slightly higher and adjust for the difference in cushion thicknesses.  I'll look at that and see if anyone else has this issue and another solution.
>> Thanks, Dave Hupe1994 Cat 320 (#32)Holland, MI
>>       
>