[C320-list] Converting Dining Table to Full Bed

[Chris Burti]

The cleats that were factory installed on Commitment do a good job of supporting the table inner edge and tightening the post has sufficed. I haven’t slept on it enough to comment on the effect on sleeping comfort caused by the rolled bolster on the cushion edge other than to observe that I have not noticed it. 

Best Regards,
Chris Burti
Commitment #867

> On Jul 21, 2018, at 3:36 PM, Dave Hupe <hoopdtwo at yahoo.com> wrote:
> 
> Chris-
> I have no teak blocks on the edge of the lockers/seats to support the table (this would definitely be better for support than just the center post).  Also, there is no "stop" on the support rod rather than down all the way. Plus, I wouldn't feel safe trying to tighten down the knob at a slightly higher level and expect it to hold.
> Teak blocks on the seats, or adding blocks under the table would help to keep the table slightly higher and adjust for the difference in cushion thicknesses.  I'll look at that and see if anyone else has this issue and another solution.
> Thanks, Dave Hupe1994 Cat 320 (#32)Holland, MI
> 
>