[C320-list] Rocna 15 Anchor Fit on Early C320s - Hull 268

[Scott Thompson]

I think you want the anchor snug so it doesn't bounce around in waves.


On 3/25/2018 4:22 PM, Cliff Lee wrote:
> Thank you for all your thoughtful responses - this is such a great site.
> 1.  Frank, it is possible I am snugging the anchor too tightly against the
> roller rather than trying to find the natural resting point.  I'll have to
> play a little when next at the boat.
> 2.  Chris, I looked at the Anchor Mate.  It's a great product, but I
> suspect it may not give any benefit in this case since the shank is already
> close to resting on the anchor roller deck, perhaps 0.5-1.0 inches off.  I
> suspect it would simply push the anchor up off the roller.  However, never
> say never.
> 3.  Myron, I do see another longer Windline roller on their site, so this
> will be another option.  I think it comes without any drilled holes.  Did
> you drill new holes in the new roller at the same location as the old
> roller or did you select new locations to drill into the hull?
>
> Regards,
> Cliff