[C320-list] running wires from pedestal to panel

[Ted Harrison]

You will have to take the bedding out of the aft cabin. 

Then run the wire down and follow the white vent hose. You can use the harbour freight wire tool. Mine came in 1 foot fibreglass sections that screw together. 

Next take out the small shelf under the stove.

Take out the cabinet under the sink. 

Now push the wire up to the hot water tank. 

Next open the electrical panel. Be careful and shot off all power. Push the wire feeder down with a string attached. On an angle point aft. It will come out behind the hot water tank. Hard to get but I did it. Then attach string and pull wire up and over to the GPS.

If you have lots of cable go down the front of the hot water tank and into to port cabin locker.  From there up into the electrical panel. Easier route but I had limited cable. This is by far the best route. 

Might be easier to explain over the phone. You can call me if you like. 

I will be at my boat in 40 minutes. 

Ted Harrison
Hull 424
289-387-7587. 

> On Aug 8, 2019, at 10:45 AM, Mark Gillingham <markgill at uwalumni.com> wrote:
> 
> A bit of soap can lubricate the wires so they drag more smoothly by each
> other.
> 
> On Thu, Aug 8, 2019 at 07:52 Ted Harrison <tharrison at innovations-plus.com>
> wrote:
> 
>> I purchased a wire feeder from harbour freight. It can with a hook. I
>> pushed this up the stainless steel tube. Hooked a string onto the hook and
>> pulled down. Then taped the string onto the cable and pulled it up and out.
>> 
>> Not a lot of room but just enough.
>> 
>> Ted Harrison
>> 
>> Hull 424
>> 
>>> On Aug 8, 2019, at 7:46 AM, Louis Spitz <aronella at gmail.com> wrote:
>>> 
>>> How do I run wiring from the pedestal to the panel above the nav
>> station? I’m trying to hook up a GPS,
>>> and have the GPS wiring already inside the aft cabin below the pedestal.
>> The housing is removed.
>>> Thanks.
>>> Lou Spitz
>>> #195, Merry Chase
>> 
> -- 
> Mark Gillingham | @markgillingham | 312-543-3052