[C320-list] New Battery Charger?

[islgirl3 at aol.com]

David,I replaced my charger with a 1230P and it was straight forward.  Pull the inline fuses, check for voltage on existing cables at the charger, label the cables, remove the old unit, install the new charger, cable up and test.
Rich Nuzzolo


-----Original Message-----
From: David Veeneman <davidv at veeneman.com>
To: C320 Assn Forum <c320-list at lists.catalina320.com>
Sent: Mon, Sep 23, 2019 10:01 am
Subject: [C320-list] New Battery Charger?

I’m looking for a bit of reassurance. I am getting ready to replace the battery charger on my C320, and after doing some research, I have just about settled on the ProMariner ProNautic 1240P 40 Amp <https://www.amazon.com/ProMariner-ProNautic-1240P-Battery-Charger/dp/B00MYSZL2I?ref_=ast_bbp_dp> charger. It’s a three-bank charger, and I have two dual-purpose (start and house) sealed batteries on a Off-1-2-Both switch. Battery drain is relatively light; nav system and refrigerator (occasionally).

— Any reason not to use this charger?
— Any tricks to connecting it?

Any other thoughts or suggestions? Thanks.

--
David Veeneman
Dana Point, CA
SV Adelante, C320 #131