[C320-list] Fridge compressor replacement

[Graeme Clark]

Troy
I’ve emailed some photos 

I bought the boat five years ago. The compressor was in a bad state then! The mounts were corroded and it was sliding about on the shelf! I threw some resin and glass mat at it as a stop gap, not expecting it to last the season - amazingly it has soldiered on!

Although there are gullies to take away water that runs off the locker lids, I think they can be overwhelmed in really bad weather (or overventhusiastic pressure washing) and allow a fair bit of moisture into them. Plus some owners store salty kit in that locker (fenders, lines etc) all of which add to the salt laced damp atmosphere!

Fortunately (or possibly not!) it rarely gets that hot here in the UK, so the fridge copes ok without needing the locker lid open.  

I am however thinking of removing my blower (which I replaced only four years ago and has failed again) with some sort of extraction to remove the warm air from the condenser 

Graeme



Sent from my iPad

> On 12 Jul 2020, at 22:19, Troy Dunn <troutwarrior at gmail.com> wrote:
> 
> No help here on install but if you wouldn’t mind getting a picture of the
> corrosion I'd like to know what to look for.  Our AB cold machine is
> getting long in the tooth too.
> 
> Hopefully someone will chime in with alternate locations.  I know a lot of
> folks like that location where yours is because you can open the aft locker
> to let some heat escape theoretically making it more efficient...I haven't
> seen the white paper that proves this :)...  but it sure seems logical to
> me.
> 
> 
> Troy Dunn
> Hull #514