[C320-list] stanchion leaks
Adam Green
adamgreen2 at gmail.com
Tue Mar 12 11:57:58 PDT 2024
Hey Everyone.
To re-bed stanchions do people fill with epoxy and re-drill or use sealant
and re-fit
Thanks Adam #519
On Tue, Mar 12, 2024, 12:16 PM Charles Martin via C320-list <
c320-list at lists.catalina320.com> wrote:
> Thanks so much, Steve.
>
> For laughs, here are the one lines for my electronics system (attached), a
> mix of old and new Raymarine and a Garmin GPS 421 chartplotter. I don't
> yet have the NGT-1 and iPad in the system, but I plan to add them if I need
> to debug any of the messages after final setup. Did you have any issues
> with your autohelm system getting everything to play nice during initial
> testing?
>
> Best,
> Chip Martin
> S/V Bonaventure, Sail #767
> (410) 231-0199
> chiprmartin at gmail.com
>
>
> On Mon, Mar 11, 2024 at 10:53 AM Steve Weinstein via C320-list <
> c320-list at lists.catalina320.com> wrote:
>
> > If I recall correctly, when I installed the EV-100 on my prior boat, a
> > C270, the drain wire was just connected to the regular ground. There was
> > no RF ground point. I think that it's stated somewhere in the manual
> which
> > is available online to just connect to the regular ground.
> > Steve Weinstein2000 C320 #722, Vega
> >
> > On Monday, March 11, 2024 at 10:22:32 AM EDT, Charles Martin via
> > C320-list <c320-list at lists.catalina320.com> wrote:
> >
> > Dear Shipmates:
> >
> > I'm upgrading my Raymarine ST 4000+ autohelm to the Raymarine EV-100
> > System; however, the ACU (computer) requires a ground as follows: the
> > dedicated drain wire should be connected to the vessel's RF ground point.
> >
> > My question is does the C320 have an RF ground point? If not, where have
> > others connected the ground from the ACU.
> >
> > Best,
> > Chip Martin
> > S/V Bonaventure, Sail #767
> > (410) 231-0199
> > chiprmartin at gmail.com
> >
> >
>
More information about the C320-list
mailing list